KT5500 & Clincher Backup Specifications

Torque Table

Pressure High Gear Low Gear
PSI/MPa Lbs.-ft. Nm Lbs.-ft. Nm
1000/6.89 1260 1708 6300 8542
1500/10.34 2160 2929 10800 14643
2000/13.79 3060 4149 15300 20744
2500/17.24 3960 5369 19800 26845
MAXIMUM RATED TORQUE: 18700 LBS.-FT./25354 Nm

Speed Table

Flow (US GPM/LPM) Low Gear (RPM) High Gear (RPM)
10/37.9 2.7 13.4
20/75.71 5.4 26.8
40/151.4 10.7 53.6
50/189.3 13.4 67.1
Hydraulic Requirements (max.):

50 US GPM @ 1000 psi (189 LPM @ 6.0 MPa)
10 US GPM @ 2000 psi (38 LPM @ 13.8 MPa)
Length (Doors Closed):

52"/132.1cm
Height:

60"/152.4cm
Width:

37"/94cm (Model 80-0421-3 Tension LC)
35"/89cm (Models 80-0422 & 80-0406 Comp. LC)
Space Required on Pipe:

6-3/4"/17.1cm
Maximum Elevator Diameter

N/A
Torque Arm Length:

30"/76.2cm (Tension Load Cell Configuration)
32"/81.3cm (Compression Load Cell Configuration)
- Centerline of pipe to Centerline of anchor -
Weight (Approximate):

2775 lbs./1261 Kg.
Casing Jaws Available (inches):

See Table Below
Description Part Number
2-3/8" Jaw Die Kit 1064-JDK-65
2-7/8" Jaw Die Kit 1064-JDK-70
3" Jaw Die Kit 1064-JDK-71
3-1/8" Jaw Die Kit 1064-JDK-72
3-3/8" Jaw Die Kit 1064-JDK-74
3-1/2" Jaw Die Kit 1064-JDK-75
4" Jaw Die Kit 1064-JDK-80
4-1/8" Jaw Die Kit 1064-JDK-82
4-1/2" Jaw Die Kit 1064-JDK-85
4-3/4" Jaw Die Kit 1064-JDK-87
5" Jaw Die Kit 1064-JDK-90
5-1/2" Jaw Die Kit 1064-JDK-95
95mm Jaw Die Kit 1064-JDK-77
   
Standard 3.875" FLAT DIE INSERT 12-1003